ACTUAL STATE

Problems, Crashes and Errors of Fusion 360 TODAY

Can't connect to Fusion 360? Trying to open Fusion 360 but the site is down and appears to be offline today? Check the issue below if it's down for everyone else or just you!

MAKE A DIRECT PING TO THE SITE TO KNOW ITS STATUS

Status of Fusion 360 in the last 24 hours

84%

server status

countries

111ms

Response time

ping service

To update

In Isnotdown, you will be able to instantly check if Fusion 360 works perfectly, or on the contrary, if it is registering some type of problem to offer its services.

Service

Location

$bash

The Fusion 360 service appears to be working!

Frequent failures of Fusion 360

Why does my Fusion 360 keep crashing?

This behavior may be caused by one of the following: Hardware limitations.
Network connectivity issues.
Antivirus restriction.

What are the limitations of Fusion 360?

Fusion 360 for personal use is limited to 10 active and editable documents, however can you have unlimited archived documents in your account.
Today all your designs and documents are active by default.
You can open any design no matter how old or new and they will open.
You can have as many document tabs as possible.

How do I stop Fusion 360 from freezing?

Turn off Auto-Project edges Navigate to the Design tab.
Turn off "Auto project edges on reference.
" Press OK and give it a moment to sync the preferences.
Open the file and check if creating a sketch still causes a hang or crash.

Why is Fusion 360 lagging?

Slow performance could be caused by one of the following: Hardware limitations.
Complex designs / large assemblies.
Network Connectivity issues.

Troubleshooting Tips

Step 1: Refresh your browser by pressing CTRL + F5 at the same time.

Problem solved? Still can't connect to Fusion 360? Continue with Step 2.

Step 2: Power off your modem and after restart your computer.

Turn it on again. Clear internet cookies and browser cache.
Still stuck and not enjoying Fusion 360, then go to Step 3.

Step 3: Your firewall may have blocked Fusion 360

Temporarily disable your antivirus or firewall running in the background. Now, if you can access Fusion 360, be informed that your security software is causing problems. Try adding Fusion 360 to the set of trusted sites.

Step 4 – If the problem persists, it could be a DNS failure.

DNS is a service that translates Fusion 360 into a machine-readable address called an IP address. In most cases, this job is done by your ISP. If only specific sites are not opening, it is likely to be corrupted.

Ask for direct help to the administrators of Fusion 360

There is a way to ask the administrators of Fusion 360 for help on current downtimes. Just proceed through any of the buttons below and copy the URL below and paste it into Facebook, Example or Forum pages, for reference when asking for help.

copy url